SLBEVAPAS01

SLBEVAPAS01

SLB Series Energy Harvesting Evaluation Board with 20C USB type-C charging

Nichicon “SLB” series are “Small Lithium Titanate Rechargeable Batteries” ideal for powering IoT systems. The SLBEVAPAS01 is an evaluation board that allows users to test the SLB series with combining various types of energy harvesting devices. With a built-in power management IC from E-Peas, the harvesting can be optimized via jumper configurations. The board is equipped with a rectifier for AC harvesting source. To enable fast evaluation, the board features an USB-C input for quick SLB charging with up to 400mA.

  • Built-in rectifier for solar (DC) and vibration power generation (AC)
  • Supports power collection optimization via jumper settings
  • USB -C charging with up to 20C (400mA) charge current via dip switches
  • Supports various outputs (1.14V-3.34V)
  • High customizability
  • 11 measure and test points for evaluation purposes
  • PMIC E-Peas AEM30330 with configuration jumpers (i.e. MPPT, load configuration etc.)
  • PCBA size: 110 x 60mm

This product is currently out of stock and unavailable.

SKU: N/A Category:

Description

Share this product

Additional information

ESR

Max. 12 ohm

ENERGY DENSITY

17Wh/L

NOMINAL VOLTAGE

2.4V

SPECS

SPECIFICATIONS

    • Energy harvester connection terminal: 1 system DC/AC switchable, Input voltage range: DC: 4.5V or less, AC: +/- 4.5V peak or less
    • Power supply output terminal: 2 lines
(1) SLB DC output (2.8V to 1.8V) (2) DC/DC converter output (factory set voltage: 3.3V) Can be set in the range of 3.0V to 5.0V by replacing resistors
    • Maximum power point tracking (MPPT) function (switchable)
Operating voltage: 7-mode release voltage ratio preset + input impedance adjustment mode Sampling time/period: 4 preset modes
    • SLB charge/discharge control threshold voltage setting (switchtype)
2 preset modes + custom setting mode
    • Output circuit enable setting (switch-type)
4 modes (always on / PMIC control / external control / always off)
  • One-touch connection/disconnection of SLB series is possible (no soldering required)
  • Built-in charge/discharge stop circuit at high temperaturesExternal control terminal
  • Circuit configuration allows power consumption customization according to required function
  • Test pin placement on main signal lines
  • Product dimensions: 90mm x 70mm x 12mm
Delivery and Returns Content description.

WHERE TO BUY

See All Distributors

Share